HF WIRE ANTENNAS MADE IN GERMANY
HF WIRE ANTENNASMADE  IN  GERMANY

NEWS FLASH 

Remote-Ready   Antenna 

SKY-SDR SPECIFICATIONS

GENERAL TRANSCEIVER  SPECIFICATIONS
Technology Solid State SDR-DSP  Direct Conversion
Frequencies / Bands 1.8 MHz to 54.0 MHz 160, 80, 60, 40, 30, 20, 17,               15, 12, 10, & 6m  Bands
Modes AM, CW, DIGI, FM, LSB, USB CAT: USB2  (FTDI Chip)
Digital Modes JST, PSK, RTTY, SSTV, etc. LINE IN/OUT 3.5mm Jack
Output Power 5 Watts (typical) (foldback protection for high SWR)
Antenna 50 Ohms (nominal) BNC Connection
Voltage Requirements 10.5vdc (min) to 15vdc (max) Fuse: 3.15A, 250V, Slow Blow
Current Drain RX: Avr. * 360mA;  TX: 2A  * 40mA less with backlight OFF
Frequency Stability ±3 ppm 0 to 50 degrees Centigrade
Memory 100 Memory slots  (0-99) stores freq., mode, and VFO (A/B) & other functions
Loud Speaker 1/4 Watt  
Display Backlight Always On,  Always OFF,  or  Automatic off after 3 seconds - (saves 40 mA)
Enclosure Size 12.8 x 10.7 x 5.5 cm (excluding knobs and connectors)
Working Size 14.7 x 10.7 x 7 cm (including knobs and connectors)
Weight 580 grams (20.5 oz.) (without mic)

 

RECEIVER  SPECIFICATIONS
Technology Solid State SDR-DSP  Direct Conversion
Sensitivity 0.2 u V With Preamp On
Preamp  +16 dB  
Attenuator  -6 dB  
Pre-Filtering 7 LPF and 7 BPF (cascaded) 160m, 80m, 60+40m, 30+20m, 17+15m, 12+10m, 6m
Spurious Response   Rejection IMD3: -48 dB  
Current Drain Backlight:  ON / OFF 350mA / 310mA
RX Bandscope ±24 kHz  
DSP RX Filters 4 filters (most  mode), user definable  push-button selection
        SSB Filters    (4)

4  Filters,  3  "Fixed Filters"

and 1 with Bandwidth and

Passband User Adjustable

From 250 Hz to 3600 Hz
        CW Filters     (4) From 20 Hz to 1200 Hz
        AM Filters      (4) From 2000 Hz to 9600 Hz
        FM Filters      (4) From 2000 Hz to 9600 Hz
        DIGI Modes   (1)               1 Filter Bandwidth Fixed:  3.35 kHz
DSP Noise Reduction Adjustable Level (1 to 50)  use lowest level necessary
DSP Noise Blanker Adjustable Level (4 to 12)  Adjust for minimum interference
DSP "ACE" Automatic Carrier Eliminater for SSB (only)  better than -40dB
S-Meter Bar Graph or uV readout  
CW Mode Selection CW or CWReverse Menu selectable
Squelch Adjustable for FM & Other Modes 0 to 100 / "0" = Off 

 

TRANSMITTER  SPECIFICATIONS
Output Power 5 Watts (typical) / adjustable (foldback protection for high SWR)
TX Metering Selectable: Output Power or SWR Selectable: Numerical or Bar Graph
D.C. Voltage Metering Numerical display  
VOX Adjustable Gain & Delay  
Compressor Adjustable 0-20dB  
Reverberation Adjustable  
SSB TX Mute Disable = Monitor / Enable = Mute
Key Type Selectable: Automatic = Paddle / Manual = Hand-Key
Built-In Keyer Iambic Mode A or Mode B Menu selectable
Keyer Adjustments Speed / Weight Menu adjustment
CW Sequencing Adjustable Delay From 100ms to 5 seconds
Digi Mode Gain Adjusts audio gain in digi mode  
AMP Key (PTT JACK) Keys External Amplifier   
TX DSP FILTERS 1 Filter per Mode (Adjustable)  
        SSB TX Filters      Bandwidth & Passband                                            User Adjustable From 150 Hz to 3600 Hz
        CW TX Filters From 50 Hz to 1000 Hz
        AM TX Filters From 2000 Hz to 9600 Hz
        FM TX Filters From 2000 Hz to 9600 Hz
        DIGI TX Filters               Bandwidth: Fixed:  3.35 kHz
TX Bandscope Monitors transmitted signal  

 


Druckversion | Sitemap
{{custom_footer}}